Entertainment Technology News

Phantom Camera Control Software Updated: PCC version v2.2.737.0

By StudentFilmmakers.com
posted Jul 10, 2013, 10:54

PCC version v2.2.737.0 - This version of PCC was updated.

This installer will install PCC version v2.2.737.0 Before running this installer, you might want to make a backup of your Phantom folder.  Please provide feedback via the PCC forum in the Phantom Zone at www.visionresearch.com/PhantomZone.

There are user guides and thorough software documentation available. Just navigate to the “Help” menu section to get started.

We recommend that the computer you use have a Pentium class microprocessor running 1.7 GHz or higher.  The software will install on the following operating systems:

  • Windows 7 (32 & 64 bit)
  • Windows Vista (32 & 64 bit)
  • Windows XP Pro (32 & 64 bit)
  • Windows 8 (32 & 64 bit)

We also recommend you have 4GB of memory and at least 80GB of disk space.

A more powerful computer and fast disk drive will deliver faster display and playback speeds as well as shorter save and download times.

Please visit the "Service Alerts" section in the Phantom Zone to view any known issues and work-arounds associated with this software release and current Phantom cameras.  

Warning:  This version of software has only been tested with the firmware versions shown in the table below.  It will work with these or later versions.  If your camera model does not appear below, it has not been tested with v2.2.737.0.  You're more than welcome to download the software as it will not damage the camera however please do make sure you can fully acquire, download and playback a test cine using the acquisition parameters you are going to use before you perform an actual test.

Warning:  If you are upgrading from version 663 or lower, Vision Research recommends that you run the Window Uninstall application prior to installing PCC 2.2.737.0

To check the firmware version of a camera, run your existing version of the Phantom software, connect to and select the camera of interest, go to "Help --> About" in the Phantom software. If your camera does not meet the minimum firmware requirements and you would like a firmware upgrade, please contact VRI Technical Support.

Resources:

www.visionresearch.com



www.studentfilmmakers.com © 2004-2005. All rights reserved.
A division of Welch Integrated, Inc.