Music, Sound, and Audio Technology

Lav It Up: Effectively Mic Up Your Talent

By Staff
posted Dec 1, 2009, 08:22

Check out this article in the print edition of StudentFilmmakers Magazine, May 2008. More photos included in the print edition. Click here to get a copy and to subscribe >>

Back Edition Spotlight: May 2008, StudentFilmmakers MagazineLav It Up!
Effectively Mic Up Your Talent

by Bryant Falk

Since the early 60�s, the lavalier microphone has been used to capture audio. Its concept allowed the audio engineer to get the cleanest voice recording by getting the mic closer to the source. Some problems we get from doing this include clothing shuffle, muffled sound, microphones falling off, hand smacks, and many other issues.


(Pictured) Common placement of lav mic. Fabric sitting on top will need to be stabilized as well.

The first challenge in using a lav mic is getting your talent wired up. Since concealment is key in wiring up a lav mic, it�s important you know what your talent is comfortable letting you do. I usually explain in a very diplomatic tone that the cable needs to be run on the inside of the shirt. Usually the talent will quickly run the cable up and through, then allowing you to clip the mic on top and the pack, (if it�s wireless) on the bottom. Some other options include taping the wire inside of a jacket, or if need be, to the talent directly.


(Pictured) Adding a loop to the cable reduces mic noise.

Checklist for your lav mic travel pack:

(1) Lav Mic

(2) Batteries (for wireless rigs)

(3) Gaffers Tape

(4) Double Tape/Stick (sticky on both sides)

(5) Mini Pop Filter (like the hush lav)

(6) Vampire Clip, Turtle Clip (mic cage), Leather Strap

(7) Pre-Tape (Medical Tape)

(8) No Tape Glue (used for fake beards and other facial hair)


(Pictured) Called a �Hush Lav,� this device reduces cloth from rubbing on the mic capsule.

Okay, got all the stuff? Good, now let�s get some basic rules in place, so we understand why we have what we have.


(Pictured) One of the first Lav mics ever used. Try hiding that!!

Rule 1. The lav mic needs to be hidden. (Sometimes in plain sight works; most times it doesn’t.)

Rule 2. The top or capsule area must be free of anything rubbing on it.

Rule 3. The cable must be taped down to prevent unwanted noise.

Rule 4. Make sure Rule 2 is being obeyed!

Using our double-sided tape and other glue material, we are basically creating a �pocket� or a �bubble� for the lav mic capsule to sit while getting it as centered and close to our talent�s mouth as possible. Richard Topham from Pro Sound Services was nice enough to demonstrate the many lav mic techniques you can use to get your lav effectively recording dialogue with minimal fabric and wind noise. One key focus is to get any fabric on the mic taped or glued down, so it does not rub the mic when talent moves. For example, after taping a lav mic to the actor�s sternum (chest area), it�s a good idea to add doublesided tape on either side of the mic and lightly stick the fabric of the shirt down. This will keep the fabric in that one area from moving back and forth.

There are a variety of techniques not included here, but follow the photos to see how you can effectively mic up your talent. Notice Yael (Yael Epstein) is wearing many different types of tops. This illustrates how to tackle the different challenges posed by each kind of shirt. Another option to note is the smallest of these mics (called the countryman) has many color options to allow you to further disguise what little part of the mic might actually be showing. A little mic can go a long way to getting great sound!

Photos by the author.

This article may not be reprinted in print or internet publications without express permission of StudentFilmmakers.com. Photos may not be copied or reproduced.

Check out this article in the May 2008 print edition of StudentFilmmakers magazine, page 26. More photos included in the print edition. Click here to get a copy of the May 2008 Edition, so you can read and enjoy all of the excellent articles inside.

About the Author:

Author Bryant FalkBryant Falk has been a producer and engineer for over 12 years working with such clients as The Ricki Lake Show, Coca-Cola, Sports Illustrated, Valley National Bank, and MTV�s The Shop. His company Abacus Audio (www.abacusaudio.com) handles many aspects of the audio production field from creative and production to mixing and final output.

 

Resources:

About StudentFilmmakers Magazine & StudentFilmmakers.com >>

Join the Film and Digital Networking Community >>

Post Your Films, Videos, Reels, and Trailers >>

Discuss Motion Picture Techniques in the Online Industry Forums >>

Get the StudentFilmmakers.com E-Newsletter >>

Subscribe to the Magazine >>

StudentFilmmakers magazine would like to hear from you!
Click here
to share your comments and feedback about the magazine, monthly editions, your favorite articles, and your favorite topics.

We always welcome and appreciate your Reader Comments. View them here, and send yours to the editorial team today!